The Aeldari Starweaver kit builds a single Harlequin skimmer transport — and the same sprues also build the Voidweaver gun platform variant. Magnets let one model swap between the two roles, plus give the flight stand the right angle so the hull sits flat. Below are our recommendations for the kit, the flight stand, and a few sibling Aeldari builds.
Magnetizing the Starweaver / Voidweaver Kit
The turret is the swap point between the two builds. The Starweaver carries a shuriken cannon turret; the Voidweaver carries a haywire cannon turret. Magnetize the turret base so a single hull can run as either profile.
You can use either a 3mm x 2mm disc magnet or a 3mm x 3mm x 2mm block magnet. The block magnets keep the turret from freely rotating, though it can still pivot 90 degrees. The disc magnets are easier to drill into the turret, though the height gain at that point is minimal.
[Buy Product=100pcs-3mm-x-2mm-1-8-x-1-16-disc-magnets,Variant=All]
[Buy Product=100pcs-3mm-x-3mm-x-2mm-1-8x1-8x1-16-block-magnets,Variant=All]
Flight Stand
The Starweaver and Voidweaver both ship with a flight stem. The underside of the hull is sloped, so a flat stand causes the model to nose downward. We recommend the Large Posable – Short Magnetic Flight Stand instead — the posable joint lets the hull sit level to the table.
[Buy Product=large40k,Variant=All]
For a peel-and-stick option that works with clear skimmer bases, use the Peel & Stick Inner Base Magnets — no drilling required.
[Buy Product=flexible-self-adhesive-magnets,variant=51483453948194]
For a set of replacement bases with preset magnet holes, use these bases with magnets.
[Buy Product=bases-premagnetized-warhammer,variant=30427499626580]